Файловый менеджер - Редактировать - /usr/src/linux-headers-5.4.0-200/drivers/infiniband/ulp/ipoib/Kconfig
Назад
# SPDX-License-Identifier: GPL-2.0-only config INFINIBAND_IPOIB tristate "IP-over-InfiniBand" depends on NETDEVICES && INET && (IPV6 || IPV6=n) ---help--- Support for the IP-over-InfiniBand protocol (IPoIB). This transports IP packets over InfiniBand so you can use your IB device as a fancy NIC. See Documentation/infiniband/ipoib.rst for more information config INFINIBAND_IPOIB_CM bool "IP-over-InfiniBand Connected Mode support" depends on INFINIBAND_IPOIB default n ---help--- This option enables support for IPoIB connected mode. After enabling this option, you need to switch to connected mode through /sys/class/net/ibXXX/mode to actually create connections, and then increase the interface MTU with e.g. ifconfig ib0 mtu 65520. WARNING: Enabling connected mode will trigger some packet drops for multicast and UD mode traffic from this interface, unless you limit mtu for these destinations to 2044. config INFINIBAND_IPOIB_DEBUG bool "IP-over-InfiniBand debugging" if EXPERT depends on INFINIBAND_IPOIB default y ---help--- This option causes debugging code to be compiled into the IPoIB driver. The output can be turned on via the debug_level and mcast_debug_level module parameters (which can also be set after the driver is loaded through sysfs). This option also creates a directory tree under ipoib/ in debugfs, which contains files that expose debugging information about IB multicast groups used by the IPoIB driver. config INFINIBAND_IPOIB_DEBUG_DATA bool "IP-over-InfiniBand data path debugging" depends on INFINIBAND_IPOIB_DEBUG ---help--- This option compiles debugging code into the data path of the IPoIB driver. The output can be turned on via the data_debug_level module parameter; however, even with output turned off, this debugging code will have some performance impact.
| ver. 1.4 |
Github
|
.
| PHP 7.4.3-4ubuntu2.24 | Генерация страницы: 0 |
proxy
|
phpinfo
|
Настройка