Файловый менеджер - Редактировать - /usr/src/linux-headers-5.4.0-200/drivers/net/hippi/Kconfig
Назад
# SPDX-License-Identifier: GPL-2.0-only # # HIPPI network device configuration # config HIPPI bool "HIPPI driver support" depends on INET && PCI ---help--- HIgh Performance Parallel Interface (HIPPI) is a 800Mbit/sec and 1600Mbit/sec dual-simplex switched or point-to-point network. HIPPI can run over copper (25m) or fiber (300m on multi-mode or 10km on single-mode). HIPPI networks are commonly used for clusters and to connect to super computers. If you are connected to a HIPPI network and have a HIPPI network card in your computer that you want to use under Linux, say Y here (you must also remember to enable the driver for your HIPPI card below). Most people will say N here. if HIPPI config ROADRUNNER tristate "Essential RoadRunner HIPPI PCI adapter support" depends on PCI ---help--- Say Y here if this is your PCI HIPPI network card. To compile this driver as a module, choose M here: the module will be called rrunner. If unsure, say N. config ROADRUNNER_LARGE_RINGS bool "Use large TX/RX rings" depends on ROADRUNNER ---help--- If you say Y here, the RoadRunner driver will preallocate up to 2 MB of additional memory to allow for fastest operation, both for transmitting and receiving. This memory cannot be used by any other kernel code or by user space programs. Say Y here only if you have the memory. endif # HIPPI
| ver. 1.4 |
Github
|
.
| PHP 7.4.3-4ubuntu2.24 | Генерация страницы: 0 |
proxy
|
phpinfo
|
Настройка