Файловый менеджер - Редактировать - /var/www/xthruster/html/wp-content/uploads/flags/bus.tar
Назад
Kconfig 0000644 00000013552 14722073077 0006066 0 ustar 00 # SPDX-License-Identifier: GPL-2.0 # # Bus Devices # menu "Bus devices" config ARM_CCI bool config ARM_CCI400_COMMON bool select ARM_CCI config ARM_CCI400_PORT_CTRL bool depends on ARM && OF && CPU_V7 select ARM_CCI400_COMMON help Low level power management driver for CCI400 cache coherent interconnect for ARM platforms. config BRCMSTB_GISB_ARB bool "Broadcom STB GISB bus arbiter" depends on ARM || ARM64 || MIPS default ARCH_BRCMSTB || BMIPS_GENERIC help Driver for the Broadcom Set Top Box System-on-a-chip internal bus arbiter. This driver provides timeout and target abort error handling and internal bus master decoding. config MOXTET tristate "CZ.NIC Turris Mox module configuration bus" depends on SPI_MASTER && OF help Say yes here to add support for the module configuration bus found on CZ.NIC's Turris Mox. This is needed for the ability to discover the order in which the modules are connected and to get/set some of their settings. For example the GPIOs on Mox SFP module are configured through this bus. config HISILICON_LPC bool "Support for ISA I/O space on HiSilicon Hip06/7" depends on ARM64 && (ARCH_HISI || COMPILE_TEST) select INDIRECT_PIO help Driver to enable I/O access to devices attached to the Low Pin Count bus on the HiSilicon Hip06/7 SoC. config IMX_WEIM bool "Freescale EIM DRIVER" depends on ARCH_MXC help Driver for i.MX WEIM controller. The WEIM(Wireless External Interface Module) works like a bus. You can attach many different devices on it, such as NOR, onenand. config MIPS_CDMM bool "MIPS Common Device Memory Map (CDMM) Driver" depends on CPU_MIPSR2 help Driver needed for the MIPS Common Device Memory Map bus in MIPS cores. This bus is for per-CPU tightly coupled devices such as the Fast Debug Channel (FDC). For this to work, either your bootloader needs to enable the CDMM region at an unused physical address on the boot CPU, or else your platform code needs to implement mips_cdmm_phys_base() (see asm/cdmm.h). config MVEBU_MBUS bool depends on PLAT_ORION help Driver needed for the MBus configuration on Marvell EBU SoCs (Kirkwood, Dove, Orion5x, MV78XX0 and Armada 370/XP). config OMAP_INTERCONNECT tristate "OMAP INTERCONNECT DRIVER" depends on ARCH_OMAP2PLUS help Driver to enable OMAP interconnect error handling driver. config OMAP_OCP2SCP tristate "OMAP OCP2SCP DRIVER" depends on ARCH_OMAP2PLUS help Driver to enable ocp2scp module which transforms ocp interface protocol to scp protocol. In OMAP4, USB PHY is connected via OCP2SCP and in OMAP5, both USB PHY and SATA PHY is connected via OCP2SCP. config QCOM_EBI2 bool "Qualcomm External Bus Interface 2 (EBI2)" depends on HAS_IOMEM depends on ARCH_QCOM || COMPILE_TEST default ARCH_QCOM help Say y here to enable support for the Qualcomm External Bus Interface 2, which can be used to connect things like NAND Flash, SRAM, ethernet adapters, FPGAs and LCD displays. config SIMPLE_PM_BUS tristate "Simple Power-Managed Bus Driver" depends on OF && PM help Driver for transparent busses that don't need a real driver, but where the bus controller is part of a PM domain, or under the control of a functional clock, and thus relies on runtime PM for managing this PM domain and/or clock. An example of such a bus controller is the Renesas Bus State Controller (BSC, sometimes called "LBSC within Bus Bridge", or "External Bus Interface") as found on several Renesas ARM SoCs. config SUN50I_DE2_BUS bool "Allwinner A64 DE2 Bus Driver" default ARM64 depends on ARCH_SUNXI select SUNXI_SRAM help Say y here to enable support for Allwinner A64 DE2 bus driver. It's mostly transparent, but a SRAM region needs to be claimed in the SRAM controller to make the all blocks in the DE2 part accessible. config SUNXI_RSB tristate "Allwinner sunXi Reduced Serial Bus Driver" default MACH_SUN8I || MACH_SUN9I || ARM64 depends on ARCH_SUNXI select REGMAP help Say y here to enable support for Allwinner's Reduced Serial Bus (RSB) support. This controller is responsible for communicating with various RSB based devices, such as AXP223, AXP8XX PMICs, and AC100/AC200 ICs. config TEGRA_ACONNECT tristate "Tegra ACONNECT Bus Driver" depends on ARCH_TEGRA depends on OF && PM help Driver for the Tegra ACONNECT bus which is used to interface with the devices inside the Audio Processing Engine (APE) for Tegra210 and later. config TEGRA_GMI tristate "Tegra Generic Memory Interface bus driver" depends on ARCH_TEGRA help Driver for the Tegra Generic Memory Interface bus which can be used to attach devices such as NOR, UART, FPGA and more. config TI_SYSC bool "TI sysc interconnect target module driver" depends on ARCH_OMAP2PLUS help Generic driver for Texas Instruments interconnect target module found on many TI SoCs. config TS_NBUS tristate "Technologic Systems NBUS Driver" depends on SOC_IMX28 depends on OF_GPIO && PWM help Driver for the Technologic Systems NBUS which is used to interface with the peripherals in the FPGA of the TS-4600 SoM. config UNIPHIER_SYSTEM_BUS tristate "UniPhier System Bus driver" depends on ARCH_UNIPHIER && OF default y help Support for UniPhier System Bus, a simple external bus. This is needed to use on-board devices connected to UniPhier SoCs. config VEXPRESS_CONFIG bool "Versatile Express configuration bus" default y if ARCH_VEXPRESS depends on ARM || ARM64 depends on OF select REGMAP help Platform configuration infrastructure for the ARM Ltd. Versatile Express. config DA8XX_MSTPRI bool "TI da8xx master peripheral priority driver" depends on ARCH_DAVINCI_DA8XX help Driver for Texas Instruments da8xx master peripheral priority configuration. Allows to adjust the priorities of all master peripherals. source "drivers/bus/fsl-mc/Kconfig" endmenu Makefile 0000644 00000002110 14722073077 0006207 0 ustar 00 # SPDX-License-Identifier: GPL-2.0 # # Makefile for the bus drivers. # # Interconnect bus drivers for ARM platforms obj-$(CONFIG_ARM_CCI) += arm-cci.o obj-$(CONFIG_HISILICON_LPC) += hisi_lpc.o obj-$(CONFIG_BRCMSTB_GISB_ARB) += brcmstb_gisb.o obj-$(CONFIG_MOXTET) += moxtet.o # DPAA2 fsl-mc bus obj-$(CONFIG_FSL_MC_BUS) += fsl-mc/ obj-$(CONFIG_IMX_WEIM) += imx-weim.o obj-$(CONFIG_MIPS_CDMM) += mips_cdmm.o obj-$(CONFIG_MVEBU_MBUS) += mvebu-mbus.o # Interconnect bus driver for OMAP SoCs. obj-$(CONFIG_OMAP_INTERCONNECT) += omap_l3_smx.o omap_l3_noc.o obj-$(CONFIG_OMAP_OCP2SCP) += omap-ocp2scp.o obj-$(CONFIG_QCOM_EBI2) += qcom-ebi2.o obj-$(CONFIG_SUN50I_DE2_BUS) += sun50i-de2.o obj-$(CONFIG_SUNXI_RSB) += sunxi-rsb.o obj-$(CONFIG_SIMPLE_PM_BUS) += simple-pm-bus.o obj-$(CONFIG_TEGRA_ACONNECT) += tegra-aconnect.o obj-$(CONFIG_TEGRA_GMI) += tegra-gmi.o obj-$(CONFIG_TI_SYSC) += ti-sysc.o obj-$(CONFIG_TS_NBUS) += ts-nbus.o obj-$(CONFIG_UNIPHIER_SYSTEM_BUS) += uniphier-system-bus.o obj-$(CONFIG_VEXPRESS_CONFIG) += vexpress-config.o obj-$(CONFIG_DA8XX_MSTPRI) += da8xx-mstpri.o fsl-mc/Kconfig 0000644 00000001014 14722073077 0007235 0 ustar 00 # SPDX-License-Identifier: GPL-2.0 # # DPAA2 fsl-mc bus # # Copyright (C) 2014-2016 Freescale Semiconductor, Inc. # config FSL_MC_BUS bool "QorIQ DPAA2 fsl-mc bus driver" depends on OF && (ARCH_LAYERSCAPE || (COMPILE_TEST && (ARM || ARM64 || X86_LOCAL_APIC || PPC))) select GENERIC_MSI_IRQ_DOMAIN help Driver to enable the bus infrastructure for the QorIQ DPAA2 architecture. The fsl-mc bus driver handles discovery of DPAA2 objects (which are represented as Linux devices) and binding objects to drivers. fsl-mc/Makefile 0000644 00000000623 14722073077 0007377 0 ustar 00 # SPDX-License-Identifier: GPL-2.0 # # Freescale Management Complex (MC) bus drivers # # Copyright (C) 2014 Freescale Semiconductor, Inc. # obj-$(CONFIG_FSL_MC_BUS) += mc-bus-driver.o mc-bus-driver-objs := fsl-mc-bus.o \ mc-sys.o \ mc-io.o \ dpbp.o \ dpcon.o \ dprc.o \ dprc-driver.o \ fsl-mc-allocator.o \ fsl-mc-msi.o \ dpmcp.o
| ver. 1.4 |
Github
|
.
| PHP 7.4.3-4ubuntu2.24 | Генерация страницы: 0 |
proxy
|
phpinfo
|
Настройка