Файловый менеджер - Редактировать - /usr/src/linux-headers-5.4.0-200/include/sound/sof/dai-intel.h
Назад
/* SPDX-License-Identifier: (GPL-2.0 OR BSD-3-Clause) */ /* * This file is provided under a dual BSD/GPLv2 license. When using or * redistributing this file, you may do so under either license. * * Copyright(c) 2018 Intel Corporation. All rights reserved. */ #ifndef __INCLUDE_SOUND_SOF_DAI_INTEL_H__ #define __INCLUDE_SOUND_SOF_DAI_INTEL_H__ #include <sound/sof/header.h> /* ssc1: TINTE */ #define SOF_DAI_INTEL_SSP_QUIRK_TINTE (1 << 0) /* ssc1: PINTE */ #define SOF_DAI_INTEL_SSP_QUIRK_PINTE (1 << 1) /* ssc2: SMTATF */ #define SOF_DAI_INTEL_SSP_QUIRK_SMTATF (1 << 2) /* ssc2: MMRATF */ #define SOF_DAI_INTEL_SSP_QUIRK_MMRATF (1 << 3) /* ssc2: PSPSTWFDFD */ #define SOF_DAI_INTEL_SSP_QUIRK_PSPSTWFDFD (1 << 4) /* ssc2: PSPSRWFDFD */ #define SOF_DAI_INTEL_SSP_QUIRK_PSPSRWFDFD (1 << 5) /* ssc1: LBM */ #define SOF_DAI_INTEL_SSP_QUIRK_LBM (1 << 6) /* here is the possibility to define others aux macros */ #define SOF_DAI_INTEL_SSP_FRAME_PULSE_WIDTH_MAX 38 #define SOF_DAI_INTEL_SSP_SLOT_PADDING_MAX 31 /* SSP clocks control settings * * Macros for clks_control field in sof_ipc_dai_ssp_params struct. */ /* mclk 0 disable */ #define SOF_DAI_INTEL_SSP_MCLK_0_DISABLE BIT(0) /* mclk 1 disable */ #define SOF_DAI_INTEL_SSP_MCLK_1_DISABLE BIT(1) /* mclk keep active */ #define SOF_DAI_INTEL_SSP_CLKCTRL_MCLK_KA BIT(2) /* bclk keep active */ #define SOF_DAI_INTEL_SSP_CLKCTRL_BCLK_KA BIT(3) /* fs keep active */ #define SOF_DAI_INTEL_SSP_CLKCTRL_FS_KA BIT(4) /* bclk idle */ #define SOF_DAI_INTEL_SSP_CLKCTRL_BCLK_IDLE_HIGH BIT(5) /* SSP Configuration Request - SOF_IPC_DAI_SSP_CONFIG */ struct sof_ipc_dai_ssp_params { struct sof_ipc_hdr hdr; uint16_t reserved1; uint16_t mclk_id; uint32_t mclk_rate; /* mclk frequency in Hz */ uint32_t fsync_rate; /* fsync frequency in Hz */ uint32_t bclk_rate; /* bclk frequency in Hz */ /* TDM */ uint32_t tdm_slots; uint32_t rx_slots; uint32_t tx_slots; /* data */ uint32_t sample_valid_bits; uint16_t tdm_slot_width; uint16_t reserved2; /* alignment */ /* MCLK */ uint32_t mclk_direction; uint16_t frame_pulse_width; uint16_t tdm_per_slot_padding_flag; uint32_t clks_control; uint32_t quirks; uint32_t bclk_delay; /* guaranteed time (ms) for which BCLK * will be driven, before sending data */ } __packed; /* HDA Configuration Request - SOF_IPC_DAI_HDA_CONFIG */ struct sof_ipc_dai_hda_params { struct sof_ipc_hdr hdr; uint32_t link_dma_ch; } __packed; /* DMIC Configuration Request - SOF_IPC_DAI_DMIC_CONFIG */ /* This struct is defined per 2ch PDM controller available in the platform. * Normally it is sufficient to set the used microphone specific enables to 1 * and keep other parameters as zero. The customizations are: * * 1. If a device mixes different microphones types with different polarity * and/or the absolute polarity matters the PCM signal from a microphone * can be inverted with the controls. * * 2. If the microphones in a stereo pair do not appear in captured stream * in desired order due to board schematics choises they can be swapped with * the clk_edge parameter. * * 3. If PDM bit errors are seen in capture (poor quality) the skew parameter * that delays the sampling time of data by half cycles of DMIC source clock * can be tried for improvement. However there is no guarantee for this to fix * data integrity problems. */ struct sof_ipc_dai_dmic_pdm_ctrl { struct sof_ipc_hdr hdr; uint16_t id; /**< PDM controller ID */ uint16_t enable_mic_a; /**< Use A (left) channel mic (0 or 1)*/ uint16_t enable_mic_b; /**< Use B (right) channel mic (0 or 1)*/ uint16_t polarity_mic_a; /**< Optionally invert mic A signal (0 or 1) */ uint16_t polarity_mic_b; /**< Optionally invert mic B signal (0 or 1) */ uint16_t clk_edge; /**< Optionally swap data clock edge (0 or 1) */ uint16_t skew; /**< Adjust PDM data sampling vs. clock (0..15) */ uint16_t reserved[3]; /**< Make sure the total size is 4 bytes aligned */ } __packed; /* This struct contains the global settings for all 2ch PDM controllers. The * version number used in configuration data is checked vs. version used by * device driver src/drivers/dmic.c need to match. It is incremented from * initial value 1 if updates done for the to driver would alter the operation * of the microhone. * * Note: The microphone clock (pdmclk_min, pdmclk_max, duty_min, duty_max) * parameters need to be set as defined in microphone data sheet. E.g. clock * range 1.0 - 3.2 MHz is usually supported microphones. Some microphones are * multi-mode capable and there may be denied mic clock frequencies between * the modes. In such case set the clock range limits of the desired mode to * avoid the driver to set clock to an illegal rate. * * The duty cycle could be set to 48-52% if not known. Generally these * parameters can be altered within data sheet specified limits to match * required audio application performance power. * * The microphone clock needs to be usually about 50-80 times the used audio * sample rate. With highest sample rates above 48 kHz this can relaxed * somewhat. * * The parameter wake_up_time describes how long time the microphone needs * for the data line to produce valid output from mic clock start. The driver * will mute the captured audio for the given time. The min_clock_on_time * parameter is used to prevent too short clock bursts to happen. The driver * will keep the clock active after capture stop if this time is not yet * met. The unit for both is microseconds (us). Exceed of 100 ms will be * treated as an error. */ struct sof_ipc_dai_dmic_params { struct sof_ipc_hdr hdr; uint32_t driver_ipc_version; /**< Version (1..N) */ uint32_t pdmclk_min; /**< Minimum microphone clock in Hz (100000..N) */ uint32_t pdmclk_max; /**< Maximum microphone clock in Hz (min...N) */ uint32_t fifo_fs; /**< FIFO sample rate in Hz (8000..96000) */ uint32_t reserved_1; /**< Reserved */ uint16_t fifo_bits; /**< FIFO word length (16 or 32) */ uint16_t reserved_2; /**< Reserved */ uint16_t duty_min; /**< Min. mic clock duty cycle in % (20..80) */ uint16_t duty_max; /**< Max. mic clock duty cycle in % (min..80) */ uint32_t num_pdm_active; /**< Number of active pdm controllers */ uint32_t wake_up_time; /**< Time from clock start to data (us) */ uint32_t min_clock_on_time; /**< Min. time that clk is kept on (us) */ uint32_t unmute_ramp_time; /**< Length of logarithmic gain ramp (ms) */ /* reserved for future use */ uint32_t reserved[5]; /**< variable number of pdm controller config */ struct sof_ipc_dai_dmic_pdm_ctrl pdm[0]; } __packed; /* ALH Configuration Request - SOF_IPC_DAI_ALH_CONFIG */ struct sof_ipc_dai_alh_params { struct sof_ipc_hdr hdr; uint32_t stream_id; /* reserved for future use */ uint32_t reserved[15]; } __packed; #endif
| ver. 1.4 |
Github
|
.
| PHP 7.4.3-4ubuntu2.24 | Генерация страницы: 0 |
proxy
|
phpinfo
|
Настройка