Файловый менеджер - Редактировать - /usr/src/linux-headers-5.4.0-200/arch/mips/include/asm/sgi/mc.h
Назад
/* * This file is subject to the terms and conditions of the GNU General Public * License. See the file "COPYING" in the main directory of this archive * for more details. * * mc.h: Definitions for SGI Memory Controller * * Copyright (C) 1996 David S. Miller * Copyright (C) 1999 Ralf Baechle * Copyright (C) 1999 Silicon Graphics, Inc. */ #ifndef _SGI_MC_H #define _SGI_MC_H struct sgimc_regs { u32 _unused0; volatile u32 cpuctrl0; /* CPU control register 0, readwrite */ #define SGIMC_CCTRL0_REFS 0x0000000f /* REFS mask */ #define SGIMC_CCTRL0_EREFRESH 0x00000010 /* Memory refresh enable */ #define SGIMC_CCTRL0_EPERRGIO 0x00000020 /* GIO parity error enable */ #define SGIMC_CCTRL0_EPERRMEM 0x00000040 /* Main mem parity error enable */ #define SGIMC_CCTRL0_EPERRCPU 0x00000080 /* CPU bus parity error enable */ #define SGIMC_CCTRL0_WDOG 0x00000100 /* Watchdog timer enable */ #define SGIMC_CCTRL0_SYSINIT 0x00000200 /* System init bit */ #define SGIMC_CCTRL0_GFXRESET 0x00000400 /* Graphics interface reset */ #define SGIMC_CCTRL0_EISALOCK 0x00000800 /* Lock CPU from memory for EISA */ #define SGIMC_CCTRL0_EPERRSCMD 0x00001000 /* SysCMD bus parity error enable */ #define SGIMC_CCTRL0_IENAB 0x00002000 /* Allow interrupts from MC */ #define SGIMC_CCTRL0_ESNOOP 0x00004000 /* Snooping I/O enable */ #define SGIMC_CCTRL0_EPROMWR 0x00008000 /* Prom writes from cpu enable */ #define SGIMC_CCTRL0_WRESETPMEM 0x00010000 /* Perform warm reset, preserves mem */ #define SGIMC_CCTRL0_LENDIAN 0x00020000 /* Put MC in little-endian mode */ #define SGIMC_CCTRL0_WRESETDMEM 0x00040000 /* Warm reset, destroys mem contents */ #define SGIMC_CCTRL0_CMEMBADPAR 0x02000000 /* Generate bad perr from cpu to mem */ #define SGIMC_CCTRL0_R4KNOCHKPARR 0x04000000 /* Don't chk parity on mem data reads */ #define SGIMC_CCTRL0_GIOBTOB 0x08000000 /* Allow GIO back to back writes */ u32 _unused1; volatile u32 cpuctrl1; /* CPU control register 1, readwrite */ #define SGIMC_CCTRL1_EGIOTIMEO 0x00000010 /* GIO bus timeout enable */ #define SGIMC_CCTRL1_FIXEDEHPC 0x00001000 /* Fixed HPC endianness */ #define SGIMC_CCTRL1_LITTLEHPC 0x00002000 /* Little endian HPC */ #define SGIMC_CCTRL1_FIXEDEEXP0 0x00004000 /* Fixed EXP0 endianness */ #define SGIMC_CCTRL1_LITTLEEXP0 0x00008000 /* Little endian EXP0 */ #define SGIMC_CCTRL1_FIXEDEEXP1 0x00010000 /* Fixed EXP1 endianness */ #define SGIMC_CCTRL1_LITTLEEXP1 0x00020000 /* Little endian EXP1 */ u32 _unused2; volatile u32 watchdogt; /* Watchdog reg rdonly, write clears */ u32 _unused3; volatile u32 systemid; /* MC system ID register, readonly */ #define SGIMC_SYSID_MASKREV 0x0000000f /* Revision of MC controller */ #define SGIMC_SYSID_EPRESENT 0x00000010 /* Indicates presence of EISA bus */ u32 _unused4[3]; volatile u32 divider; /* Divider reg for RPSS */ u32 _unused5; u32 eeprom; /* EEPROM byte reg for r4k */ #define SGIMC_EEPROM_PRE 0x00000001 /* eeprom chip PRE pin assertion */ #define SGIMC_EEPROM_CSEL 0x00000002 /* Active high, eeprom chip select */ #define SGIMC_EEPROM_SECLOCK 0x00000004 /* EEPROM serial clock */ #define SGIMC_EEPROM_SDATAO 0x00000008 /* Serial EEPROM data-out */ #define SGIMC_EEPROM_SDATAI 0x00000010 /* Serial EEPROM data-in */ u32 _unused6[3]; volatile u32 rcntpre; /* Preload refresh counter */ u32 _unused7; volatile u32 rcounter; /* Readonly refresh counter */ u32 _unused8[13]; volatile u32 giopar; /* Parameter word for GIO64 */ #define SGIMC_GIOPAR_HPC64 0x00000001 /* HPC talks to GIO using 64-bits */ #define SGIMC_GIOPAR_GFX64 0x00000002 /* GFX talks to GIO using 64-bits */ #define SGIMC_GIOPAR_EXP064 0x00000004 /* EXP(slot0) talks using 64-bits */ #define SGIMC_GIOPAR_EXP164 0x00000008 /* EXP(slot1) talks using 64-bits */ #define SGIMC_GIOPAR_EISA64 0x00000010 /* EISA bus talks 64-bits to GIO */ #define SGIMC_GIOPAR_HPC264 0x00000020 /* 2nd HPX talks 64-bits to GIO */ #define SGIMC_GIOPAR_RTIMEGFX 0x00000040 /* GFX device has realtime attr */ #define SGIMC_GIOPAR_RTIMEEXP0 0x00000080 /* EXP(slot0) has realtime attr */ #define SGIMC_GIOPAR_RTIMEEXP1 0x00000100 /* EXP(slot1) has realtime attr */ #define SGIMC_GIOPAR_MASTEREISA 0x00000200 /* EISA bus can act as bus master */ #define SGIMC_GIOPAR_ONEBUS 0x00000400 /* Exists one GIO64 pipelined bus */ #define SGIMC_GIOPAR_MASTERGFX 0x00000800 /* GFX can act as a bus master */ #define SGIMC_GIOPAR_MASTEREXP0 0x00001000 /* EXP(slot0) can bus master */ #define SGIMC_GIOPAR_MASTEREXP1 0x00002000 /* EXP(slot1) can bus master */ #define SGIMC_GIOPAR_PLINEEXP0 0x00004000 /* EXP(slot0) has pipeline attr */ #define SGIMC_GIOPAR_PLINEEXP1 0x00008000 /* EXP(slot1) has pipeline attr */ u32 _unused9; volatile u32 cputp; /* CPU bus arb time period */ u32 _unused10[3]; volatile u32 lbursttp; /* Time period for long bursts */ /* MC chip can drive up to 4 bank 4 SIMMs each. All SIMMs in bank must * be the same size. The size encoding for supported SIMMs is bellow */ u32 _unused11[9]; volatile u32 mconfig0; /* Memory config register zero */ u32 _unused12; volatile u32 mconfig1; /* Memory config register one */ #define SGIMC_MCONFIG_BASEADDR 0x000000ff /* Base address of bank*/ #define SGIMC_MCONFIG_RMASK 0x00001f00 /* Ram config bitmask */ #define SGIMC_MCONFIG_BVALID 0x00002000 /* Bank is valid */ #define SGIMC_MCONFIG_SBANKS 0x00004000 /* Number of subbanks */ u32 _unused13; volatile u32 cmacc; /* Mem access config for CPU */ u32 _unused14; volatile u32 gmacc; /* Mem access config for GIO */ /* This define applies to both cmacc and gmacc registers above. */ #define SGIMC_MACC_ALIASBIG 0x20000000 /* 512MB home for alias */ /* Error address/status regs from GIO and CPU perspectives. */ u32 _unused15; volatile u32 cerr; /* Error address reg for CPU */ u32 _unused16; volatile u32 cstat; /* Status reg for CPU */ #define SGIMC_CSTAT_RD 0x00000100 /* read parity error */ #define SGIMC_CSTAT_PAR 0x00000200 /* CPU parity error */ #define SGIMC_CSTAT_ADDR 0x00000400 /* memory bus error bad addr */ #define SGIMC_CSTAT_SYSAD_PAR 0x00000800 /* sysad parity error */ #define SGIMC_CSTAT_SYSCMD_PAR 0x00001000 /* syscmd parity error */ #define SGIMC_CSTAT_BAD_DATA 0x00002000 /* bad data identifier */ #define SGIMC_CSTAT_PAR_MASK 0x00001f00 /* parity error mask */ #define SGIMC_CSTAT_RD_PAR (SGIMC_CSTAT_RD | SGIMC_CSTAT_PAR) u32 _unused17; volatile u32 gerr; /* Error address reg for GIO */ u32 _unused18; volatile u32 gstat; /* Status reg for GIO */ #define SGIMC_GSTAT_RD 0x00000100 /* read parity error */ #define SGIMC_GSTAT_WR 0x00000200 /* write parity error */ #define SGIMC_GSTAT_TIME 0x00000400 /* GIO bus timed out */ #define SGIMC_GSTAT_PROM 0x00000800 /* write to PROM when PROM_EN not set */ #define SGIMC_GSTAT_ADDR 0x00001000 /* parity error on addr cycle */ #define SGIMC_GSTAT_BC 0x00002000 /* parity error on byte count cycle */ #define SGIMC_GSTAT_PIO_RD 0x00004000 /* read data parity on pio */ #define SGIMC_GSTAT_PIO_WR 0x00008000 /* write data parity on pio */ /* Special hard bus locking registers. */ u32 _unused19; volatile u32 syssembit; /* Uni-bit system semaphore */ u32 _unused20; volatile u32 mlock; /* Global GIO memory access lock */ u32 _unused21; volatile u32 elock; /* Locks EISA from GIO accesses */ /* GIO dma control registers. */ u32 _unused22[15]; volatile u32 gio_dma_trans; /* DMA mask to translation GIO addrs */ u32 _unused23; volatile u32 gio_dma_sbits; /* DMA GIO addr substitution bits */ u32 _unused24; volatile u32 dma_intr_cause; /* DMA IRQ cause indicator bits */ u32 _unused25; volatile u32 dma_ctrl; /* Main DMA control reg */ /* DMA TLB entry 0 */ u32 _unused26[5]; volatile u32 dtlb_hi0; u32 _unused27; volatile u32 dtlb_lo0; /* DMA TLB entry 1 */ u32 _unused28; volatile u32 dtlb_hi1; u32 _unused29; volatile u32 dtlb_lo1; /* DMA TLB entry 2 */ u32 _unused30; volatile u32 dtlb_hi2; u32 _unused31; volatile u32 dtlb_lo2; /* DMA TLB entry 3 */ u32 _unused32; volatile u32 dtlb_hi3; u32 _unused33; volatile u32 dtlb_lo3; u32 _unused34[0x0392]; u32 _unused35; volatile u32 rpsscounter; /* Chirps at 100ns */ u32 _unused36[0x1000/4-2*4]; u32 _unused37; volatile u32 maddronly; /* Address DMA goes at */ u32 _unused38; volatile u32 maddrpdeflts; /* Same as above, plus set defaults */ u32 _unused39; volatile u32 dmasz; /* DMA count */ u32 _unused40; volatile u32 ssize; /* DMA stride size */ u32 _unused41; volatile u32 gmaddronly; /* Set GIO DMA but don't start trans */ u32 _unused42; volatile u32 dmaddnpgo; /* Set GIO DMA addr + start transfer */ u32 _unused43; volatile u32 dmamode; /* DMA mode config bit settings */ u32 _unused44; volatile u32 dmaccount; /* Zoom and byte count for DMA */ u32 _unused45; volatile u32 dmastart; /* Pedal to the metal. */ u32 _unused46; volatile u32 dmarunning; /* DMA op is in progress */ u32 _unused47; volatile u32 maddrdefstart; /* Set dma addr, defaults, and kick it */ }; extern struct sgimc_regs *sgimc; #define SGIMC_BASE 0x1fa00000 /* physical */ /* Base location of the two ram banks found in IP2[0268] machines. */ #define SGIMC_SEG0_BADDR 0x08000000 #define SGIMC_SEG1_BADDR 0x20000000 /* Maximum size of the above banks are per machine. */ #define SGIMC_SEG0_SIZE_ALL 0x10000000 /* 256MB */ #define SGIMC_SEG1_SIZE_IP20_IP22 0x08000000 /* 128MB */ #define SGIMC_SEG1_SIZE_IP26_IP28 0x20000000 /* 512MB */ extern void sgimc_init(void); #endif /* _SGI_MC_H */
| ver. 1.4 |
Github
|
.
| PHP 7.4.3-4ubuntu2.24 | Генерация страницы: 0 |
proxy
|
phpinfo
|
Настройка